Chemistry Hoses  Manufacturers, Traders, Suppliers

Our extensive range of accessories for drum pumps, laboratory pumps, progressive cavity pumps, hand pumps and many other pump systems offers you everything you need to get the most out of your pumps. Adapters, hoses, foot strainers, nozzles, flow meters and many other accessories improve the efficiency and safety of your pumps.

As there are many applications in the range between 100°C and 200°C this series was developed. The H19 series can be used up to 190°C and is extremely inexpensive. It can also be used as a replacement for our series H2 ( 200°C) if not ,as often, 200°C are needed;

p>p>Operating temperature : max. 190°C, short-term up to 200°C
Basic hose type : according to your requirements T1, T2, T3, corrugated stainless steel hose or VA tube Basic hose types
Connection fitting : according to your requirements e.g. DKR, DKL, RSL, RSS, AGR, BDN etc. or flanges in normal steel bichrom.., 1.4301, 1.4571 etc. Fittings
Heating conductor : Structure according to DIN, moisture protected with protective braiding
Temperature sensors : Fe-CuNi (J), NiCr-Ni (K), PT100
Thermal insulation : closed-cell foam hose
Outer protective braiding : polymide braiding, others possible on request z.B. Metal braiding, Pa corrugated hose etc. External protection
Supply line : standard 1.5 meter with 7-pin plug, longer or shorter on request
Caps : silicone or PA hard caps
Nominal voltage : 230V, other voltages possible on request
Test voltage : 2000V high voltage test
Power : see power table, or according to your wishes
Tolerances :
Heat output : + 5% / - 10%
Diameter : +/- 10%
Length : +/- 2%
Temperature : +/- 10°C

Heating and heat loss-free transport of:
oil, fat, wax, glue, paints, tar, water, milk, chocolate, carbon dioxide, plastics, resins, sealants and adhesives, acids, lyes, engine exhaust gases, industrial gases, blast furnace gases, air, casting compounds etc.