Thermal simulation  Manufacturers, Traders, Suppliers

An injection moulding simulation shows the process of filling and cooling (thermoplastics) or cross-linking (silicone/rubber) with the influence of the mould (e.g. temperature control and gating situation) even before the mould is designed.
Through qualified simulation and expert interpretation of the results, possible moulded part and tool errors can be detected at an early stage. This is the basis for component optimisation.
We're simulating:

• Filling
• Shrinkage and warpage
• Tool temperature control
• Sprue situation
• Reprint profile
• Thermoplastics
• Process parameters
• different media and materials
• inserts / overmouldings

We analyze:

• Default
• Cycle time
• Clamping forces
• Fitting error
• Injection pressure on cores
• recognizable optimization potential
• Planning and calculation

Our offer:

• Simulation of the results of component optimisation
• Possibly calculated negative correction
• allowance determination for glass fibre reinforced components
• Creation of tool concepts as a basis for the simulation

Your advantages:

• high process reliability
• better component quality
• Avoidance of change loops
• optimal preparation for the tool design
• when implemented with IsoForm® tools, it is not uncommon for good parts to be produced during the first sampling

Let`s make your product a success together!