Fine Filtration  Manufacturers, Traders, Suppliers

The filter system is fitted with a pump with a flow rate of 20 litres per minute. The system is designed for emptying and filling applications. The filter unit consists of stainless steel casing (max. pressure: 10 bar) and a free jet centrifuge. The two components can be operated separately or in series (first the filter and then the centrifuge). The filter pore sizes range from 100m to 0.5m. Practical examples The used oil is pumped directly from the engine via the filter into the tank. The filtered oil can either be pumped back into the engine, or - by setting the ball valves accordingly - it can be circulated through the centrifuge once again for further purification. The individual switching options are shown in a table. The mobile filter system is fitted with a safety valve and a differential pressure switch. This automatically shuts down the system when the filter cartridges have reached the end of their service lives.

Core competencies

• Maximum filter area per element
• Separation limit selection
• Module and sealing concept
• Robust material properties
• Application variety of the membranes

Functionality
INSIDE CéRAM membranes are operated according to the principle of crossflow (cross-flow filtration). The filtrate / permeate is pressed through the membrane, which is located on the inside of the channels, by the pressure difference between the inside and outside of the channels. All particles or molecules whose diameter is larger than the pore diameter of the membrane are retained. At the same time, the shear forces generated by the membrane overflow prevent the formation of a filter cake and thus lead to continuous cleaning of the membrane. The membranes are used in stainless steel module housings. The specially developed sealing system offers the greatest possible safety in process operation and optimum protection for the membrane.

The main areas of application for the membranes are filtration and separation processes in the food and beverage industry, chemical process technology, biotechnology and water and wastewater treatment. As standard, TAMI distributes multi-channel membranes with non-circular channel geometries. This maximizes the active filter area per membrane element. The membranes under the brand "InsideCeRAM" are offered in a total of 13 different separation limits together with stainless steel housings in 6 different size classes.

Vmat FT fine filter volume circulation system

stationary FT FF 1 up to 1,500 kW and FT FF 4 from 1.000 kW

mobile      FT FF 1 from 10 kW-1.500 kW

After all, the dirt from the water!

The Vmat fine filter system reliably filters solids from heating water. The filter elements used have different filter properties. While sludge separators always represent a poor compromise between pressure loss and separation efficiency, the Vmat FT can concentrate fully on filtration &.lt;/p>

           without pressure loss in the heating system.

The problem is in the heating circuit water:
During filling, oxygen inevitably also enters the system. Corrosion sets in - rust sludge is the result.
This silting up leads to extensive disturbances:

• encrusted energy generators and heat exchangers
• reduced performance
• higher wear and tear on pumps and valves
• higher environmental pollution due to higher energy supply with decreasing performance
• Deposit in the pipeline net-which causes bottlenecks

Only 1mm layer of dirt on the production area means at least 3 % worse heat transfer.
The Vmat FT can be retrofitted without great effort. It works in bypass and is connected in the return flow of the heating system. This ensures uninterrupted operation, e.g. when changing the filter.
The recommended initial filter unit is 15µm, means in the new unpolluted state the largest particle passing the filter element has a max. diameter of 15µm.
Depending on the degree of soiling, a layer of dirt builds up, this causes a refinement of the filtration, so that dirt with grain sizes below 1µm is filtered out. If the filter element is clogged (max. differential pressure of 1.5 bar) the unit switches off. The filter will now be cleaned or replaced.