Silo Discharge Technology  Manufacturers, Traders, Suppliers

AIR INJE CT OR LOOS ENING SYSTEM
The air injector loosening system is used to fluidize lazy flowing, technically dry, non-sticky, powdery products. The advantag e of the air injector loosening system is that the injectors are not located directly in the stream of bulk material and can be replaced from the out side. Use in a series of pulses while discharching material is recommended.

• 3, 4 or 6 special injectors with check valve, for installation into silo cone.
• Plastic reinforced tube, filter pressure reducing unit, assembled solenoid valve with mounting clamp for installation on silo cone or silo bracket
• The pre cleaned air is connected on site to the service unit with a suitable tube. The air flows through the oil and water separator into the pressure reducing unit which throttles the air pressure to the necessary level (approx 0,5 bar) . By activating the solenoid valve, the compressed-air flows through the plastic reinforced tube to the check valves, which are located directly in front of the air injectors, to finally fluidize the bulk material.
• With on site mounted maintenance unit