Power Measurement  Manufacturers, Traders, Suppliers

MBS AG, ‘Sulzbach Messwandler’ manufacture currently over 9500 low voltage current transformers of the series 0.5 with a max. operating voltage of 0.72 kV (1 kV for type CTB 31.35) acc. to IEC 61869-1/2 adhering at all times to the technical regulations applicable. The most recent information is always relevant.
The main spheres of operation, encompassing our products, are notably in the machine-, and panel board manufacturing, shipbuilding, as well as in the windturbine industry.
Due to an immensely large range of current transformers combined with customer oriented specialists, the MBS AG, ‘Sulzbach Messwandler’ will always be able to offer their patrons a tailormade solution for their low voltage current transformers requirements.

• Switchgear Manufacturer
• Industrial Building
• Energy companies
• Photovoltaic
• Engineering
• Automation
• Environment
• Wind power
• Electroplating
• Shipbuilding

- Switchgear Manufacturer
- Industrial Building
- Energy companies
- Photovoltaic
- Engineering
- Automation
- Environment
- Wind power
- Electroplating
- Shipbuilding
Further applications:

• Renewable Energy
• Water Pumps
• Wind Turbine
• Sewage plants
• Motor Control Gear
• Navy

Measuring and a network analysis gives them the security to recognize and correct interferences in the power supply at an early stage. We know the important quality standards and carry out short-term or long-term measurements on the spot using state-of-the-art calibrated measuring instruments. Just as important as correct measurement is the evaluation afterwards and the measurement report

We know the important quality standards and carry out short or long-term measurements on site with the most modern, calibrated measuring equipment. Just as important as the correct measurement is the evaluation afterwards and the measurement report.

• Current, voltage (3-phase with neutral and protective conductor) in medium-voltage and low-voltage networks
• Power (average values, peak values, lowest values) in any measuring period
• Power quality measurements according to EN50160, IEC 61000-2-4 and DACHCZ
• Harmonics measurements (current and voltage)
• Thermography in electrical and switchgear engineering
• Monitoring your ripple control signal

SERVICE is what we focus on. Good power factor correction equipment must be optimally suited to power line conditions.
Therefore we offer:

• power metering using a power recorder
• power line analysis, analysis of harmonics
• consulting and repair service, also start-up and adjustment through our partners