Sawmill Technology  Manufacturers, Traders, Suppliers

Your cutting expert for the entire world of metals.
225 years of manufacturing, 225 years of tools, 225 years of passion: We are proudly looking back on a long tradition while facing the future with excitement. Complex materials are opening up new markets and alloys are developing along with higher requirements of their products behind. This requires new and innovative cutting solutions. Our specialists are being challenged with the demands of many different markets – daily. We are familiar with the materials and their cross sections – over all industries and down to
the detail.
Our operational structures allow us to quickly and individually address the individual need of our customers and develop optimal solutions close to you. We will assist you from the first question up to fine-tuning. Even at your site if required.
Saw blades from ARNTZ are high-performance tools – economical, precise and perfectly matched to the relevant application. Our actions are guided by our high quality standards and our passion for what we do. We deliver sawing technology „Made in Germany“ that you can depend on worldwide – promised !

During the last years, our block band saws have been mainly used in sawmills due to their stability and their operating safety. However, they do not want only block band saws, but full Wimmer saw units with mechanization and many special wishes. We are the right partner for sawmills in the area of special wishes at a reasonable price. One of these units that we have constructed and produced specifically following customer wishes is located in Schongau in the facilities of the company Osenstätter.
Specifications of the customer:
Cutting length up to 14 mtr., cut material brushed on both sides, cut material sorting left-right-back
Board thicknesses of 7mm to 80mm, quality evaluation of the log after every cut, full automatics, operation by one person who must perform the following tasks.
1. Operation of the Wimmer-saw and during the sawing process
2. Quality evaluation
3. Removal of the cut material
4. Sorting by quality
5. Gripping of every single board (Lamellae)