Leakage Testing  Manufacturers, Traders, Suppliers

Services made to measure - Accredited according to 17025:2005
In our own test centre or directly at our customers' premises we provide all services of conventional non-destructive testing. The methods and procedures we use are comprehensive and always correspond to the latest state of the art: The spectrum ranges from incoming and outgoing inspections, leakage tests and checks of dimensional accuracy to quality assurance accompanying series production and special test procedures.

testing systems:

• X-ray [RT]: Mobile X-ray systems and isotopes are equipped for every application. In addition, a large X-ray bunker is available. strong>

CETA Testsysteme GmbH
Solution Partner for industrial Leak Testing and Flow Measurement
CETA Testsysteme GmbH develops and manufactures leak tester and flow test devices ("Made in Germany") and has more than 30 years of experience in solving industrial inspection tasks. The test media used are compressed air and hydrogen. The customers use the test equipment for quality assurance and production assurance in the production line. The wide range of services includes consulting, feasibility analysis, putting into operation, training, maintenance and calibration. CETA is certified according to DIN ISO 9001 and won the Quality Award North-Rhine-Westphalia in 2002 in the industry division. Since 2012, CETA has consistently been awarded a very good credit rating. Since 2004, the calibration laboratory (D-K-19566) has been accredited according to DIN EN ISO / IEC 17025 for the measurand pressure. The internationally recognized DAkkS calibration certificate complies with the requirements of the IATF 16949 standard valid in the automotive industry. With cooperation partners in currently 14 countries as well as several thousands of test equipment used worldwide, CETA presents itself as a competent solution partner for industrial leak and flow testing.
For further information visit www.cetatest.com

The automtativ test leak ATL01 serves to check a complete leak test facility in the automatic or semiautomatic application cyclically during the running manufacturing for her correct work. The device disposes of all necessary connections to the remote control or for adapting to the pressure test circuit between test part and leak testing set.
The necessary execution parametres can be removed by the setter in the ATL01 failsafe. The data can be changed only under use of a key switch by authorised persons.
The test execution can be carried out as follows:

• In the running manufacturing a test part is determined as an OK part
• Afterwards the same test part is checked in the device again. Nevertheless, this time becomes the ATL01 activeted.
• In the ATL01 the leakage must be laid on a value above the allowed thick border. Now the following leak test must have NOT OK as a result.
• In this case the attachment correctly works. Otherwise a fault is and the attachment must be checked.

Alternatively to o.g. the test results of the density testing set and the ATL01 can transmit execution to the superior control and be valued. In this case usable measuring results are. In addition, test plans and test protocols can be processed. The necessary data can be edited above a data interface located in front and PC software or be read out. Therefore it is possible to realise an automatically self testing facility.