Industrial Heating Plates  Manufacturers, Traders, Suppliers

Electric laboratory or workshop hotplate with infinitely variable output
control With or without thermostatic control.
Robust design for continuous operation.
Aluminium alloy heating plate.
By special power distribution a very even temperature is achieved over the entire heating surface.
The housing parts are made of stainless steel. The middle part is additionally painted.
Precision heating plates with electronic controller
The upper plates of the precision heating plates are made of a good heat conducting aluminium alloy and
have a smooth, easy to clean anodised surface.
The electrical long-term heating is designed in such a way that the temperature is also very even at the corners and edges.
The temperature is set on the microprocessor-controlled digital temperature controller.
Up to 99.9°C in 0.1 K steps and above 100°C in 1 K steps.
The set target temperature is retained even after the unit is switched off.
The actual temperature is indicated by 14 mm high digits.
All units have an electronic power controller with which the heating power can be adjusted from 10 to 100%.
The temperature is measured by a built-in PT 100 sensor.
The precision heating plates are equipped with a 3-pole extra-low voltage socket to which, for example, a contact thermometer or
a timer (to heat and cool the device at intervals) could be connected.
CERAN® heating
plates the low-mass CERAN® plate is electrically heated over its entire surface,
embedded in a stainless steel frame and mounted on an internally insulated stainless steel housing.
The temperature control is carried out via a NiCr-Ni temperature controller sensor (control range 50...500°C),
which is installed in a die-cast aluminium housing.
Custom-made
sand baths or baths for various liquids are possible on the basis of the heating plates.