Brake Lining Lathes  Manufacturers, Traders, Suppliers

Brake lining lathes for turning brake discs Turn off brake linings without pollution Brake linings can often become out of round after some time, so that vibrations can occur during braking. These unevenness can be removed with a brake lining lathe. The brake lining lathes belong to the group of lathes and are simply placed on the hub and straighten both linings evenly directly on the vehicle. The linings are turned off precisely so that they grip evenly again in the drum. This means that it is not always necessary to install new coverings. However, it sometimes happens that the surfaces of the brake linings become hard, so that the braking effect decreases. Here, the cutting machines can also be used, which turn off the hard surface and thus enable soft braking again. The brakes are the most important parts of a vehicle, which should always be in perfect condition. As soon as a driver notices that the brakes do not react correctly or cause noise and jerking, he should go to a garage and have the brake pads checked. The brake lining lathes work very precisely because they are firmly screwed onto the wheel hub. Many settings and the stability of these machine tools ensure accurate operation. Of course, the abrasion is extracted by dust extraction, so that there is no environmental pollution. The brake lining lathes require a 380 volt connection, which would have to be taken into account when making a purchase, therefore it is very important to find out about the suitable accessories in advance.